I just had a scary thought, are the 6400-6500 parameters in permanent memory or are they lost if the battery for memory dies? I've seen lots of forum posts of late of people having battery problems and I don't remember a single one that they posted, having figured it out. There are even more hidden parameters in the hidden parameter list, I think they are the 6400-6500 parameters, that are some sort of settings the manufacturer uses to configure the machine at the factory and luckily those didn't get messed up because I doubt if anyone on this planet still knows them. The #4 position shows more of the parameters than the #1 position and to change some parameters you have to be in the #4 position but there is more information you need that isn't in either #1 or #4 position and I'm not entirely sure where to find it all because I didn't find it all and ended up going the long route. I'm still not sure if there is a single system switch position that will show all the parameters. Position 1 does not show you all the parameters, part of the 6000 & 7000 range are not shown, parameters for the machine setup and ATC setup. Turns out when I recorded the parameters I did it with the system switch in position #1. I figured I would just reconfigure the machine through system switch position 7. Having just recorded all the machine parameters from the controller by photographing each screen. The machine lost its parameters, or glitched enough that it would not start up. Finally got back to working on the mv35/40 this week,
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |